Its Out!

Show Article

Comments (24)

Mukesh kumar - December 5, 2009 at 4:36am

its nice

Reply · Like · Mark as Spam

Silvio6 - September 11, 2008 at 4:44am

After having had this \"An unknow error occured (1600)\" tens of time, I finally succeded ! I was tring to do it with PwnageTool from Mac and from Windows, both never suceeded. Finally, I simply used QuickPwn and it did it all !!! So simple ! I am using iTunes 8 , just had to close it when it tried to open. iPhone 1 , 2.0.2 firmware.

Reply · Like · Mark as Spam

chmark - July 20, 2008 at 9:12am

downloaded tried 5-6 times failure, then i input original at&t sim, answered not a legitimate user answered pawned before and then everything worked perfect, very important think now please reply.... Tried to unlock it with a super sim or something like that extra sim i am not quite sure which one i have, iphone responded 10 times no sim card inserted, so i thought i will just put my sim just to make sure that it recognises something and then the miracle, iphone responded sim locked and prompt to enter pin so i did it and now i have a fully unlocked iphone with version 2.o without using any extra stealth or any kind of sim just my own home carrier sim ( Greece wind) is it so easy?? what is going on?? miracle

Reply · Like · Mark as Spam

tft - July 20, 2008 at 6:29am

Worked like a charm for me. Though on one phone, that had the 04.05.xx firmware already installed we had to downgrade that first.

Reply · Like · Mark as Spam

FSY - July 20, 2008 at 3:31am

I downloaded it, however I will wait for iClarified tom post a tutorial, just to be safe. Also here is a cool digg like site where u can share your apps http://www.appdigg.com/

Reply · Like · Mark as Spam

Mike - July 20, 2008 at 2:51am

Should I use iTunes 7.7 with it?

Reply · Like · Mark as Spam

Wizurd - July 20, 2008 at 2:24am

Thomas - No, that option is no longer in the firmware... :(

Reply · Like · Mark as Spam

Mohammadreza - July 20, 2008 at 2:07am

Is it possible to change IMEI with this new Pwnage? or is it possible at all to change the IMEI for the firmware 2.0?

Reply · Like · Mark as Spam

Thomas - July 20, 2008 at 1:00am

You could enter a wrong EDGE login or password to disable it, no?

Reply · Like · Mark as Spam

Robin - July 19, 2008 at 11:08pm

Awesome, can\'t wait for your tutorial. Tried myself and just got an error when the \'simple\' version tried to enter DFU mode, and I got an error 1600 trying to restore through iTunes, had to restore the phone to get it out of Recovery mode :( UK iPhone 3G with O2, and activated already mind you.

Reply · Like · Mark as Spam

1 2 3 Next >>