Hur du jaikbreakar och låser upp din iPhone 3G, 3GS med BlackSn0w [Mac]
LIKE
TWEET
SHARE
PIN
SHARE
POST
MAIL
MORE
Posted November 3, 2009 at 11:54pm by iClarified
Detta är instruktioner för hur du jailbreakar och låser upp din iPhone 3G eller 3GS med BlackRa1n och BlackSn0w för Mac.
Dessa instruktioner fungerar med den senaste firmwaren 3.1.2, baseband 05.11.07 och iPhones som behöver hactivation. Om du redan jailbreakat din iPhone är det enklare att följa dessa instruktioner.
För dig som har en iPhone 3GS (updated Bootrom), stöder BlackRa1n bara en låst jailbreak. Det betyder att om du redan jailbreakat får ditt batteri inte ta slut helt. Om det gör det måste du ansluta din telefon till datorn och BlackRa1n en gång till.
Innan du fortsätter måste du vara säker på att har baseband 05.11.07. Detta kan du enkelt kolla genom att läsa den här guiden. Om du inte har det måste du uppdatera din firmware till 3.1.2 i iTunes innan du fortsätter.
Du hittar Windowsversionen av denna guide här. Okej, då kör vi igång..
Steg ett Öppna din webbläsare och gå till http://www.blackra1n.com. Klicka på Apple-ikonen längst ner på sidan.
Steg två När du blir tillfrågad, väljer du att spara filen till ditt skrivbord.
Steg tre Dubbelklicka på blackr1n-zipfilen för att packa upp programmet. Dubbeklicka sen på applikationen för att starta programmet.
Steg fyra Var helt säker på att din iPhone eller iPod är ansluten till datorn. Klicka sen på den stora make it ra1n-knappen.
Steg fem Din iPhone går nu in i återställningsläge.
Du kommer att se en bild på GeoHot istället för den vanliga återställningsskärmen.
BlackRa1n körs. När det är färdigt kommer din iPhone att starta om.
En popupruta med information om att BlackRa1n är en fri programvara och att du gärna får donera pengar till GeoHot på geohot@gmail.com.
Steg sex När din telefon startats om är den jailbreakad. Du kommer att se en BlackRa1n-ikon på din hemskärm. Kolla så att du har internetuppkoppling och klicka på ikonen för att starta applikationen.
Välj vilken installationsapplikation du vill använda. Välj sen sn0w om du vill låsa upp din iPhone. Klicka på Install-knappen i övre högra hörnet för att starta installationen.
BlackRa1n börjar ladda ner och installera alternativen du valde.
Om du väljer att låsa upp din iPhone med BlackSn0w kommer en förinstallationslogg visas. CommCenter stängs av och startas, så ingen omstart behövs. Om din operatör inte stöder 3G kan du stänga av det. Klicka på Close-knappen för att fortsätta.
Steg sju När du är färdig kommer BlackRa1n att uppdatera din hemskärm och du kommer att se din nya installationsapplikation på hemskärmen.
Steg åtta När du har godkänt att din installationsapplikation fungerar som den ska, ska du klicka på Uninstall blackra1n-knappen i BlackRa1n. Detta tar bort applikationen BlackRa1n från din hemskärm.
***Tack: Ett stort tack till GeoHot för att han gjort denna jailbreak och upplåsning möjlig. Även tack till dom som fick honom att göra detta så bra. Du kan donera till GeoHot genom att använda knappen nedanför. Var snäll och visa donationen för GeoHot och inte iClarified.
Add Comment
Would you like to be notified when someone replies or adds a new comment?
Yes (All Threads)
Yes (This Thread Only)
No
Notifications
Would you like to be notified when we post a new Apple news article or tutorial?
Is there any chances that BlackRa1n will totally jailbreak the new iPhone 3GS (updated Bootrom) instead of tethered jailbreak??? Because I've been connecting and jailbreak my new iPhone 3GS (updated Bootrom) to my laptop everytime the battery runs out for a year now.
I couldn't connect to Cydia (kept on getting connection errors) and couldn't download blacksn0w either, but I unlocked my phone 3G, 3.12, 5.11.07 by following Vikram's words found at http://www.hackint0sh.org/f230/95865.htm:
1. downloaded PhoneDisk (free until September)
2. downloaded blacksn0w at http://www.mediafire.com/file/qlwymezmyzw/blacksn0w.deb
3. jailbroke with PwnageTool
4. Extracted .deb and found the necessary files in the /data folder
5. Copied files to the iPhone using PhoneDisk (put files in data/System/Library/LaunchDaemons/com.apple.CommCenter.plist and data/usr/lib/blacksn0w.dylib)
6. Restarted the iPhone and my carrier came up.
Now, I'm going to back up and restore my iPhone but without using iTunes. PhoneDisk, iPhone Backup Extractor, and SQLite Database Browser makes it all possible! My last restore from backup took 54 hours; my last backup took 29 hours. I'm not ever going to backup using iTunes. I've compiled a set of instructions from browsing the web and they will help with backup and restore.
Freedom!!!
F R E E D O M!
I've once used blacksnow to reboot my iphone cuz I forgot to charge the phone and since that time, the iphone is unable to connect to wifi anymore, is there any way to fix this problem?
I use black snow to reboot my 3GS since the battery went out last night, but it has problem in connecting to the internet, it cannot find WIFI conncection, can someone tell me how to fix it?
hi.i jailbreak and unlock mi iphone-3GS-3.1.2. work is good,only one problem,when i tern power off and next mornig tern power on, mi phone go to recoverry mode,and i need using blackSnOw ageIn ??? PLEASE HALP ME.
Yep!, that's very annoying. On the 3GS that's the way it works. With the 3G you don't have that problem. However there is this one iPhone 3GS 14GB I unlocked and works just fine, doesn't matter how many time you turn it off and on you don't have to use the software; don't know why I didn't do anything different. Good Luck!
I bought the new 3gs and followed the tutorial "How to Jailbreak and Unlock Your iPhone 3G, 3GS Using BlackSn0w [Mac]". It goes right. I can used my iphone on other carrier, use wifi, used the GPS, connect youtube thought wifi. But I am not able to activate 3G. I all ready check wth my new carrier. every think is right in his side. Does anyone has an answer to this problem?
Just followed these directions plus did the LEGACY t-mobile download from Cydia to get picture messaging. Works GREAT!! But!!!!!
PLEASE HELP-- Even when I'm on WIFI it says YOUTUBE CANNOT CONNECT. Does anyone know how to fix this? 3G Unlocked iphone on T-mobile
I get a "you do not have internet connection" error.
I am currently in China, and no option to connect to ATT :)
But, I do have wifi connected.
I have a 3GS with 3.1.2
Any suggestions?
-Aaron
www.codes4discount.com [for discounts on zagg skins]
I have a jailbroken iPhone 3GS which I have powered off completely and rebooted several times using Blackra1n, today however the same process no longer works!!
When I click 'make it ra1n' the GeoHotz picture comes up as normal, after about 30 seconds or so it restarts again and comes up with the itunes connect screen, it just does this over and over! Anyone else having this problem? can anyone help? it was working fine up to today!
i just got the 3gs and i tried to jailbreak and unlock using blackra1n several times but it didn't work. there is a window showed that the phone is jailbroken but the phone itself never reboot, it always asked for restore...i have waited a long time to see if it will reboot, but didn't happen. plus i checked the version and the firmware is correct. now i have no idea, please help
If u just bought the iPhone frm apple store then restore the phone once, and then use blackra1n to JB it. After receiving the message that ur phone is jailbroken, leave ur phone connected and close the blackra1n. When u see the iTunes logo on ur phone n says that u need to restore ur phone, just reopen the blackra1n again n u should be fine.
I've had the same problem. Downloaded black ra1n, it came up with the message saying it had worked. It never rebooted, came up with the connect to itunes message on screen. Did that, and itunes told me to restore to factory settings as it was in recovery mode. Why it did not reboot I do not know, but now have lost a lot of things that I would rather have not lost!!!!! Won't be trying this again in a hurry.
please please someone help me!!!
I got my iphone 3gs exchanged today from Apple because i was having some problems. i JB and unlocked the new phone, every things seem work great. BUT as soon as it turn off, the phone lock back again. plz help me. what should i do??
I ran the program and followed the instructions and it worked for me. The only issue I have is that when I try to run programs such as DiskAid, or Iphone Browser, it shows my device as Unlocked, when clearly I just used the blackra1n program to jailbreak my phone.
Is there any way to get it so my phone can be seen as jailbroken, so that I'm able to use those programs to change system sounds.
Thank you for any suggestions.
hi for all, please i need your help, i have a friend will come form us, he will bring me iphone 3gs 16gb, i living in malaysia, can i do a jailbreak for it, and what about if i will go to us later on, i can use it there or how.
i am waiting your help, thanks.
regards
alobaydee.