HiJack is a Platform for DIY iPhone Peripherals

A group of students and faculty at the University of Michigan have created HiJack, a hardware/software platform for creating cubic-inch sensor peripherals for the iPhone.

HiJack devices harvest power and use bandwidth from the mobile phone's headset interface. The HiJack platform enables a new class of small and cheap phone-centric sensor peripherals that support plug-and-play operation.

Power
The HiJack energy harvester can supply 7.4 mW to a load with 47% power conversion efficiency when driven by a 22 kHz tone from the output from a single audio channel on the iPhone 3GS headset port, all using electronic components that cost just $2.34 in 10K volumes. We are exploring other approaches for achieving higher conversion efficiencies.


Data
The HiJack communications layer offers two data transfer schemes. The first allows 300 baud data transfer using Bell 202 FSK signaling. The second offers 8.82 kbaud using a Manchester-encoded, direct-digital communication using hardware accelerators on the HiJack microcontroller and a software-defined, digital radio modulator/demodulator on the phone. The first scheme is described in the ISLPED'10 Design Contest entry (below). The second scheme is described in the DEV'10 paper below.

Sensing
We envision a range of sensorboards including ozone, carbon monoxide, DVM, blood pressure, blood glucose, and others. But today, we only have four daughterboards: (1) a simple demo board with temperature/humidity sensors, PIR motion sensor, and potentiometer used on the early HiJack prototypes; (2) a 3-lead EKG sensor; (3) a basic soil moisture sensor; (4) a breakout board for fast prototyping on the latest generation of HiJacks.

Read More [via Ars]